Design and fabrication of electrowetting microfluidic devices

소개

전기습윤(electrowetting)을 이용한 미세물방울(micro droplet) 유송장치를
개발한 내용에 대한 요약 발표자료입니다.

목차

Introduction
Theoretical background
Experimental
Results and discussion
Conclusions

본문내용

<Abstract>
The miniaturization technology such as micro total analysis systems (μ-TAS) and lab-on-a-chip has been paid big attention for biomedical application. Microfluidic actuation with high efficiency and low power is a key issue for operating these systems. In micro systems the surface tension dominates over bulk forces because of high surface to volume ratio. Electrowetting phenomenon has been applied to manipulate discrete micro-droplet for the application in lab-on-a-chip systems by modulating the surface tension with electrical signals. It does not need complex micro-channel and additional elements such as valve, pump etc. In this thesis, digital microfluidic chip based on electrowetting on dielectric has been studied. 1,000Å of aluminum was deposited and patterned as control electrodes. Polymer thin film which gives cost effectiveness and easy process was coated as dielectric. Cross-linked poly vinyl alcohol, poly vinyl alcohol, poly vinyl acetate and poly styrene were compared. Teflon AF®, PECVD fluorocarbon and DDMS (dichloro-dimethylsilane) SAM (self-assembled monolayer) were compared and among them Teflon was finally adopted due to the lowest surface energy, the better smoothness and easier process. 2.0㎕ droplet of d.i. water dispensed onto EWOD chip and linear transportation,

참고자료

· 없음