500 MJ급 열에너지 저장 장치의 축열 및 방열 특성 (Heat Charging and Discharging Characteristics of a 500 MJ-scale Thermal Energy Storage Module)

서지정보

· 발행기관 : 한국폐기물자원순환학회
· 수록지 정보 : 한국폐기물자원순환학회지 / 37권 / 3호 / 179 ~ 187페이지
· 저자명 : 박동규, 김동주, 구재회, 김동철

초록

The domestic industrial sector accounts for more than 60% of the nation’s total energy consumption. However,approximately 10% of the energy used in the industrial sector is wasted as unused heat. The utilization of the waste heatcan not only improve the energy efficiency in both target and linked processes but also reduce greenhouse gas emissions.
In this regard, herein the focus has been placed on thermal energy storage (TES) technologies to store the waste heatand a heat delivery system incorporating mobile-TES. In particular, a 500 MJ-scale TES module based on the latent heatstorage of phase change material (PCM) was developed for the application of a heat delivery system. The TES moduleconsisted of 48 PCM units with an internal and external finned tube. Docosanol-a type of organic fatty alcohol-was usedas the thermal storage material, and steam and air were used as heat transfer fluids. The results showed that a heat of>700 MJ can be charged at a rate of 160 kW, and a hot air equivalent of approximately 550 MJ could be produced atan 85% thermal efficiency. Each unit could store the heat of 30 MJ and release the heat of 23 MJ.

영어초록

The domestic industrial sector accounts for more than 60% of the nation’s total energy consumption. However,approximately 10% of the energy used in the industrial sector is wasted as unused heat. The utilization of the waste heatcan not only improve the energy efficiency in both target and linked processes but also reduce greenhouse gas emissions.
In this regard, herein the focus has been placed on thermal energy storage (TES) technologies to store the waste heatand a heat delivery system incorporating mobile-TES. In particular, a 500 MJ-scale TES module based on the latent heatstorage of phase change material (PCM) was developed for the application of a heat delivery system. The TES moduleconsisted of 48 PCM units with an internal and external finned tube. Docosanol-a type of organic fatty alcohol-was usedas the thermal storage material, and steam and air were used as heat transfer fluids. The results showed that a heat of>700 MJ can be charged at a rate of 160 kW, and a hot air equivalent of approximately 550 MJ could be produced atan 85% thermal efficiency. Each unit could store the heat of 30 MJ and release the heat of 23 MJ.

참고자료

· 없음