연조 슬라이버의 선밀도 거동 해석. II. 연조비와 롤러 간격 효과 (Analysis of the Linear Density Behavior of Drawn Slivers. II. Effects of Draw Ratio and Roller Distance)

서지정보

· 발행기관 : 한국섬유공학회
· 수록지 정보 : 한국섬유공학회지 / 55권 / 6호 / 415 ~ 424페이지
· 저자명 : 임정호, 김종성, 허유

초록

The behavioral characteristics of sliver linear density under roller drafting operation were investigated in this study. A theoretical model describing the dynamic behavior of the staples flowing in a single direction was applied. While the model parameters remained constant, the process parameters including draw ratio and roller distance were varied. Simulations of the dynamic behavior of the drawn sliver linear density showed that it was dependent on the process conditions, and the effects varied depending on the staple length distribution. For uniform length staples, the linear density of the drawn sliver showed periodic changes at a steady state when the drawing roller distance was long. For the short drawing zone, the drawn sliver exhibited a constant steady state linear density.
Increasing the draw ratio caused the linear density to change periodically which resulted in an increase in the CV% of the drawn sliver linear density. For length distributed staples, the linear density was sensitive to the draw ratio. At a low draw ratio, for example, DR=4, the drawing zone length did not affect the sliver linear density, and a constant linear density was observed. However, at high draw ratios, for example, DR=12, the drawing zone length affected the linear density behavior of the drawn sliver, showing periodic changes in the steady state. Thus, high draw ratios and long drawing zones caused a drastic increase in the CV% of the quasi-steady state linear density. In general, the two passes of sliver in a drawing operation with low draw ratio resulted in improved properties, that is, a more even linear density of the drawn sliver than that obtained using single drawing pass with a high level draw ratio, which drastically increased the linear density.

영어초록

The behavioral characteristics of sliver linear density under roller drafting operation were investigated in this study. A theoretical model describing the dynamic behavior of the staples flowing in a single direction was applied. While the model parameters remained constant, the process parameters including draw ratio and roller distance were varied. Simulations of the dynamic behavior of the drawn sliver linear density showed that it was dependent on the process conditions, and the effects varied depending on the staple length distribution. For uniform length staples, the linear density of the drawn sliver showed periodic changes at a steady state when the drawing roller distance was long. For the short drawing zone, the drawn sliver exhibited a constant steady state linear density.
Increasing the draw ratio caused the linear density to change periodically which resulted in an increase in the CV% of the drawn sliver linear density. For length distributed staples, the linear density was sensitive to the draw ratio. At a low draw ratio, for example, DR=4, the drawing zone length did not affect the sliver linear density, and a constant linear density was observed. However, at high draw ratios, for example, DR=12, the drawing zone length affected the linear density behavior of the drawn sliver, showing periodic changes in the steady state. Thus, high draw ratios and long drawing zones caused a drastic increase in the CV% of the quasi-steady state linear density. In general, the two passes of sliver in a drawing operation with low draw ratio resulted in improved properties, that is, a more even linear density of the drawn sliver than that obtained using single drawing pass with a high level draw ratio, which drastically increased the linear density.

참고자료

· 없음