반도체 회로기판에서의 마우스바이트 결함의 고장 메커니즘과 Normalized R에 의한 검출 (Failure Mechanism of Mouse-bite Defects on Printed Circuit Boards and their Detection by Normalized R)

서지정보

· 발행기관 : 한국신뢰성학회
· 수록지 정보 : 신뢰성 응용연구 / 24권 / 4호 / 368 ~ 375페이지
· 저자명 : 박규형, 구본흔, 허석환

초록

Purpose: To identify the failure mechanism of mouse-bite defects and test a detection method that uses 4-wire resistance measurements at the location of the defect.
Methods: The failure of circuit boards due to mouse-bite defects was analyzed based on an electronic component failure analysis procedure. The hypothesis was then verified by finite element analysis and a reproducible reliability test. The normalized R, which normalizes the circuit resistance values to detect mouse-bite defects, was calculated and the probability distribution of the circuits was shown. The probability distribution including mouse-bite defects was visualized to distinguish the fault-free circuits from those above the 3-sigma upper limit.
Results: Failure mechanisms for mouse-bite defects can include increased resistance in localized areas of the circuit. This leads to Joule heating at the mouse-bite defects. Because of the mismatch in the coefficient of thermal expansion between the copper and dielectric materials, mechanical stress can be concentrated at these sites, leading to cracking. Mouse-bite defects were defined as those with a circuit width of 4 mm or less, and a circuit thickness of 7 mm or less, based on the failure analysis results. These defects were confirmed to cause open-circuit failures under use conditions. Successful detection of mouse-bite defects was confirmed based on a 3-sigma upper limit of the Normalized R metric.Conclusion: By defining the failure mechanism of the mouse-bite defects, we confirmed the possibility of detecting these sites using a 3-sigma upper limit based on the Normalized R metric measured with a 4-wire ohmmeter.

영어초록

Purpose: To identify the failure mechanism of mouse-bite defects and test a detection method that uses 4-wire resistance measurements at the location of the defect.
Methods: The failure of circuit boards due to mouse-bite defects was analyzed based on an electronic component failure analysis procedure. The hypothesis was then verified by finite element analysis and a reproducible reliability test. The normalized R, which normalizes the circuit resistance values to detect mouse-bite defects, was calculated and the probability distribution of the circuits was shown. The probability distribution including mouse-bite defects was visualized to distinguish the fault-free circuits from those above the 3-sigma upper limit.
Results: Failure mechanisms for mouse-bite defects can include increased resistance in localized areas of the circuit. This leads to Joule heating at the mouse-bite defects. Because of the mismatch in the coefficient of thermal expansion between the copper and dielectric materials, mechanical stress can be concentrated at these sites, leading to cracking. Mouse-bite defects were defined as those with a circuit width of 4 mm or less, and a circuit thickness of 7 mm or less, based on the failure analysis results. These defects were confirmed to cause open-circuit failures under use conditions. Successful detection of mouse-bite defects was confirmed based on a 3-sigma upper limit of the Normalized R metric.Conclusion: By defining the failure mechanism of the mouse-bite defects, we confirmed the possibility of detecting these sites using a 3-sigma upper limit based on the Normalized R metric measured with a 4-wire ohmmeter.

참고자료

· 없음