구아검 첨가가 3D 프린팅을 위한 수리미 혼합물의 특성에 미치는 영향 (Effects of Guar Gum Addition on Optimal Properties of Fish Surimi Mixture for 3D Printing)

서지정보

· 발행기관 : 한국수산과학회
· 수록지 정보 : 한국수산과학회지 / 56권 / 6호 / 790 ~ 797페이지
· 저자명 : 나현식, 김동현, 이하영, 이상민, 유현지, 서고운, 고창현, 박선우, 최형욱, 최예진, 조미정, 김동우, 안동현

초록

Guar gum is an edible starch extracted from Cyamopsis tetragonolobus and used as an auxiliary ingredient to enhance the viscosity and adhesiveness of food and improve its emulsification stability. Here, characteristics of fish surimi mixture with various added amounts (0, 0.23, 0.45, 0.67, and 0.89 wt%) of guar gum were analyzed. In unheated surimi with guar gum, the pH decreased as the content increased. In the color values analysis, only the b* (yellowness) increased depending on the amount of added guar gum. The firmness increased with increasing guar gum content, and no significant difference in adhesiveness was observed. In heated surimi, a* (redness) and b* decreased in a contentdependent manner, and L* (lightness) was higher than that of unheated surimi. Regarding physical properties, the highest values of hardness, gumminess, and chewiness were observed in the heated surimi with 0.67 wt% of guar gum. However, no significant change was observed in springiness and cohesiveness. Results of sensory evaluation indicated that with higher guar gum content, only the hardness increased slightly, and significant differences were absent in the remaining parameters. Thus, surimi with 0.67 wt% of guar gum is considered to be optimal for 3D printing.

영어초록

Guar gum is an edible starch extracted from Cyamopsis tetragonolobus and used as an auxiliary ingredient to enhance the viscosity and adhesiveness of food and improve its emulsification stability. Here, characteristics of fish surimi mixture with various added amounts (0, 0.23, 0.45, 0.67, and 0.89 wt%) of guar gum were analyzed. In unheated surimi with guar gum, the pH decreased as the content increased. In the color values analysis, only the b* (yellowness) increased depending on the amount of added guar gum. The firmness increased with increasing guar gum content, and no significant difference in adhesiveness was observed. In heated surimi, a* (redness) and b* decreased in a contentdependent manner, and L* (lightness) was higher than that of unheated surimi. Regarding physical properties, the highest values of hardness, gumminess, and chewiness were observed in the heated surimi with 0.67 wt% of guar gum. However, no significant change was observed in springiness and cohesiveness. Results of sensory evaluation indicated that with higher guar gum content, only the hardness increased slightly, and significant differences were absent in the remaining parameters. Thus, surimi with 0.67 wt% of guar gum is considered to be optimal for 3D printing.

참고자료

· 없음