선박용 LED 등기구의 알루미늄 합금 방열판의 방열성능 향상을 위한 플라즈마 전해 산화의 공정변수 선정에 관한 연구 (Process Parameter Selection for Plasma Electrolytic Oxidation to Improve Heat Dissipation Performance of Aluminum Alloy Heat Sink for Shipboard LED Luminaries)

서지정보

· 발행기관 : 한국표면공학회
· 수록지 정보 : 한국표면공학회지 / 51권 / 6호 / 415 ~ 420페이지
· 저자명 : 이정형, 정인교, 한민수

초록

The possibility of an improvement in heat dissipation performance of aluminum alloy heat sink for shipboard LED luminaries through plasma electrolytic oxidation (PEO) was investigated. Four different PEO coatings were produced on aluminum alloy 5052 in silicate based alkaline solution by varying current density (50 ~200 mA/cm2). On voltage-time response curves, three stages were clearly distinguished at all current densities, namely an initial linear increase, slowdown of increase rate, and steady state(constant voltage). It was found that the increase in current density caused the breakdown voltage to increase. Two different surface morphologies – coralline porous structure and pancake structure – were confirmed by SEM examination. The coralline porous structure was predominant in the coatings produced at lower current densities (50 and 100 mA/cm2) while under high current densities(150 and 200 mA/cm2) the pancake structure became dominant. The coating thickness was measured and found to be in a range between about 13 μm and 44 μm, showing increasing thickness with increasing current density. As a result, 100 mA/cm2 was proposed as an effective process parameter to improve the heat dissipation performance of aluminum alloy heat sink, which could lower the LED operating temperature by about 30%.

영어초록

The possibility of an improvement in heat dissipation performance of aluminum alloy heat sink for shipboard LED luminaries through plasma electrolytic oxidation (PEO) was investigated. Four different PEO coatings were produced on aluminum alloy 5052 in silicate based alkaline solution by varying current density (50 ~200 mA/cm2). On voltage-time response curves, three stages were clearly distinguished at all current densities, namely an initial linear increase, slowdown of increase rate, and steady state(constant voltage). It was found that the increase in current density caused the breakdown voltage to increase. Two different surface morphologies – coralline porous structure and pancake structure – were confirmed by SEM examination. The coralline porous structure was predominant in the coatings produced at lower current densities (50 and 100 mA/cm2) while under high current densities(150 and 200 mA/cm2) the pancake structure became dominant. The coating thickness was measured and found to be in a range between about 13 μm and 44 μm, showing increasing thickness with increasing current density. As a result, 100 mA/cm2 was proposed as an effective process parameter to improve the heat dissipation performance of aluminum alloy heat sink, which could lower the LED operating temperature by about 30%.

참고자료

· 없음