CCNA2 5과 Lab Activity (실험내용) 보고서

소개

CCNA2 의 Lab activity입니다.

실제로 실험하고 작성한 보고서이며, CCNA자격증 공부 및 실험 레포트를 작성하실 때 모범 답안이

될 것입니다.

[포함내용]

Lab 5.1.3
Lab 5.1.5
Lab 5.2.3
Lab 5.2.5

목차

Lab 5.1.3
Lab 5.1.5
Lab 5.2.3
Lab 5.2.5

본문내용

Lab 5.1.3 Using the boot system Command

Objective
Display information about the Cisco IOS Image (software) that is currently running.
Determine where the IOS is booting from.
Check the amount of RAM, Flash and NVRAM memory the router has.
Check the IOS image and Flash for space used and available.
Document the parts of the IOS image file name.
Check and document the configuration register settings related to boot method.
Document a fallback boot sequence.
Background/Preparation
Setup a network as displayed in the figure. Any router that meets the interface requirements may be
used. Possible routers include 800, 1600, 1700, 2500, 2600 routers, or a combination. Refer to the
chart at the end of the lab to correctly identify the interface identifiers to be used based on the
equipment in the lab. The configuration output used in this lab is produced from 1721 series routers.
Any other router used may produce slightly different output. Start a HyperTerminal session as
performed in the Establishing a HyperTerminal session lab.

113 - 281 CCNA 2: Routers and Routing Basics v 3.1 - Lab 5.1.3 Copyright 2003, Cisco Systems, Inc.
Step 1 Login to the router
a. Connect to the router and login.
Step 2 Enter privileged EXEC mode
a. Enter enable at the command prompt.

---------상기 요약에는 실험결과를 캡쳐한 화면이 빠져 있습니다-------
---------실제 보고서에는 실험결과가 함께 나타나 있습니다 -------

참고자료

· 없음