소형 터빈 개발의 어려움과 3D 프린팅을 통한 부품 개발 Difficulty in developing small turbines and components development through 3D printing

목차

1. Introduction

2. Body
1) article contents introduction
2) Structure and cooling system of turbine
3) Key methods of 3D printing and Part prototype development

3. Conclusion

참고 문헌

본문내용

The energy of modern society is consumed by changing into the form of electricity. Various renewable energy is being studied to replace the thermal power generation . Because most of the renewable energy converts the energy into the form of kinetic energy of the generator and producing electricity through the generator, there is only a difference in energy sources, but the principle of producing power is not much different from the thermal power generation. Thermal power generation uses heat from burning fossil fuels to expand steam and the kinetic energy of the resulting fluid is converted to electrical energy through turbines connected to the generator. There is only difference is that nuclear fusion power, one of the representatives of new energy, is also given heat through nuclear reactions but the structure, the heat makes the flow of fluid and turns the turbine to obtain the kinetic energy of the turbine, is the same.

참고자료

· Southwest Research Institute. "3D printed impeller allows unmanned aircraft to operate for thousands of hours." ScienceDaily. ScienceDaily, 4 September 2018. <www.sciencedaily.com/releases/2018/09/180904114622.htm>.
· 노명수 저, <항공기 가스 터빈 엔진>, 2017, 성안당
· 이기훈 저, <세상을 변화시키는 새로운 혁명 3D 프린터 A to Z>, 2014, 인투북스