기본계측실험

소개

성균관 대학교에서 실시하고 있는
진동 및 동적 시스템 실험 중 기본계측 실험에 대한 레포트 입니다.
영어로 작성 되어 있습니다.

목차

LIST
Preliminary Report

1 Purpose of Lab
2 Related Theorem
2.1 Resistance
2.2 Circuit`s resistance value
3 Equipment
3.1 Digtal multimeter
3.2 Oscilloscope
3.3 Function generator
4 Procedure
4.1 Digtal multimeter
4.2 Oscilloscope
4.3 Function generator

Result Report

5 Result of lab
5.1 Digtal multimeter
5.2 Oscilloscope & Function generator
6 Discuss the results
6.1 Digtal multimeter & errors
6.2 Function generator
6.3 Oscilloscope
6.4 Errors in function generator and oscilloscope
6.5 Review on Labview and Data Acquisition Board

Reference

본문내용

1 Purpose of Lab
At this lab, we would learn how we could use digital multimeter, oscilloscope and function generator. Actullay students in mechanical engineering are not familar with electronic system. So in this lab we have to learn how to operate these electoronic analizing equipment. Learning and using this tools, we can develop our basic measurement abilities for analyzing a circuit and check a circuit we designed.

At first, we`ll measure resistance value using digital multimeter and learn about the circuit organized with some resistances.

And then, we will learn how to use oscilloscope and function generator to get a signal we want.

Also we will analaize the signals we get.

After this lab we would understand NI ELVIS suitable program for analyzing a elcronic circuit.

2 Related Theorem
2.1 resistance
2.1.1 Resistance value
We used three resistance during lab. At that time, we just measured and recorded a value of the each resistance and circuit. But assistant teacher said there are four color line in a resistance and each color line has a specific value for representing the ohm value of resistance. So, I searched meaning of the color line.

참고자료

· Principles and application of electrical engineering by giorgio rizzoni
· Dynamics analysis and design of systems in motion , Tongue Sheppard. Wiley
· http://www.kostic.niu.edu/