목업 평가(Mock-up Test)를 통한 바닥 건식난방 패널의 표면온도 분포 분석 및 개선 방안 (Analysis and Improvement Strategy of the Surface Temperature Distribution in a Prefabricated Floor Heating Panel through Mock-up Test)

서지정보

· 발행기관 : 한국생활환경학회
· 수록지 정보 : 한국생활환경학회지 / 20권 / 4호 / 490 ~ 505페이지
· 저자명 : 정창호, 이규동, 여명석, 김광우

초록

In this study, the surface temperature of a floor panel was measured during space heating, in a mock-up residential house in which a typical prefabricated floor heating panel was installed. Characteristics of the surface temperature distribution were analyzed, and improvement strategies for the surface temperature distribution were derived. Then, the improved effect on the surface temperature distribution for each derived alternative was compared and analyzed.
The mock-up test result showed that the higher the supply water temperature, the more disadvantageous it was, in terms of the highest value, and the deviation of the surface floor temperature. Therefore, strategies to improve the surface floor distribution by increasing the vertical and horizontal heat transfer efficiency in the floor panel are needed. So, these strategies should permit the supply of relatively low temperature water. Four alternatives reflecting each improvement strategy were derived, and, through experiment, the U type panel was selected as the most effective alternative for vertical heat transfer efficiency and horizontally even heat distribution. Under the condition of the same supply water temperature(70oC, 60oC, and 50oC), compared with the typical prefabricated floor heating panel before improvement, the highest surface floor temperature was improved from 39.8oC, 28.9oC, 25.1oC, to 36.1oC, 33.6oC, 29.9oC, respectively, and the maximum deviation of surface temperature also was reduced from 8.5 K, 7.8 K, 7.0 K, to 4.6 K, 3.8 K, 2.6 K, respectively, in the U type prefabricated floor heating panel. These results showed that the vertical and horizontal heat transfer efficiency were improved in the U type prefabricated floor heating panel.

영어초록

In this study, the surface temperature of a floor panel was measured during space heating, in a mock-up residential house in which a typical prefabricated floor heating panel was installed. Characteristics of the surface temperature distribution were analyzed, and improvement strategies for the surface temperature distribution were derived. Then, the improved effect on the surface temperature distribution for each derived alternative was compared and analyzed.
The mock-up test result showed that the higher the supply water temperature, the more disadvantageous it was, in terms of the highest value, and the deviation of the surface floor temperature. Therefore, strategies to improve the surface floor distribution by increasing the vertical and horizontal heat transfer efficiency in the floor panel are needed. So, these strategies should permit the supply of relatively low temperature water. Four alternatives reflecting each improvement strategy were derived, and, through experiment, the U type panel was selected as the most effective alternative for vertical heat transfer efficiency and horizontally even heat distribution. Under the condition of the same supply water temperature(70oC, 60oC, and 50oC), compared with the typical prefabricated floor heating panel before improvement, the highest surface floor temperature was improved from 39.8oC, 28.9oC, 25.1oC, to 36.1oC, 33.6oC, 29.9oC, respectively, and the maximum deviation of surface temperature also was reduced from 8.5 K, 7.8 K, 7.0 K, to 4.6 K, 3.8 K, 2.6 K, respectively, in the U type prefabricated floor heating panel. These results showed that the vertical and horizontal heat transfer efficiency were improved in the U type prefabricated floor heating panel.

참고자료

· 없음