Feasibility of Fabricating HDPE Nanocomposites Using a Specially Designed Friction Stir Process Tooling System

서지정보

· 발행기관 : 한국고분자학회
· 수록지 정보 : 폴리머 / 42권 / 1호 / 20 ~ 28페이지
· 저자명 : B. Balamugundan, L. Karthikeyan, M. Puviyarasan

초록

Polymer nanocomposites are being increasingly used in a variety of tribological applications owing to their structural features. In this study, high density polyethylene (HDPE) composites with three different nanoparticles such as alumina (Al2O3), multi-walled carbon nanotubes (MWCNT) and graphene were fabricated using a newly designed friction stir processing tool and fixture. Mechanical test results showed that the fabricated polymer nanocomposites possess enhanced mechanical properties at higher tool rotational speed and traverse feed. The frictional coefficient and wear properties of the fabricated polymer nanocomposites were evaluated under dry sliding conditions using a pin-on-disc tribometer.
Further the surfaces of the fabricated samples before and after wear studies were evaluated using scanning electron microscope. The wear test results showed that the HDPE/MWCNT has a very low mass loss as compared with HDPE/graphene, HDPE/Al2O3 composites and HDPE parent material. Moreover MWCNT particles act as a lubricant during wear test causing the worn surface of HDPE/MWCNT nanocomposites to be smoother as compared to other fabricated nanocomposites. The higher reflection peak between 23.71o to 23.95o obtained using X-ray diffraction (XRD) for the HDPE nanocomposites fabricated with the nanoparticles MWCNT, Al2O3 and graphene reveal a uniform mixture of the polymer matrix with the nanoparticles. The XRD results also show that the addition of nanoparticles does not significantly alter the crystal structure of the HDPE matrix.

참고자료

· 없음