CCNA2 11과 Lab Activity (실험내용) 보고서

소개

CCNA2 의 Lab activity입니다.

실제로 실험하고 작성한 보고서이며, CCNA자격증 공부 및 실험 레포트를 작성하실 때 모범 답안이

될 것입니다.

[포함내용]

Lab 11.2.1 a
Lab 11.2.1 b
Lab 11.2.2 a
Lab 11.2.2 b
Lab 11.2.3 a

목차

Lab 11.2.1 a
Lab 11.2.1 b
Lab 11.2.2 a
Lab 11.2.2 b
Lab 11.2.3 a

본문내용

Lab 11.2.1a Configuring Standard Access Lists

Objective
Configure, and apply a standard ACL to permit or deny specific traffic.
Test the ACL to determine if the desired results were achieved.

Background/Preparation
Cable a network similar to the one in the diagram. Any router that meets the interface requirements
displayed on the above diagram, such as 800, 1600, 1700, 2500, 2600 routers, or a combination,
may be used. Please refer to the chart at the end of the lab to correctly identify the interface
identifiers to be used based on the equipment in the lab. The configuration output used in this lab is
produced from 1721 series routers. Any other router used may produce a slightly different output.
The following steps are intended to be executed on each router unless specifically instructed
otherwise.
Start a HyperTerminal session as performed in the Establishing a HyperTerminal session lab.
Note: Go to the erase and reload instructions at the end of this lab. Perform those steps on the
router in this lab assignment before continuing.
238 - 281 CCNA 2: Routers and Routing Basics v 3.1 - Lab 11.2.1a Copyright 2003, Cisco Systems, Inc.


---------상기 요약에는 실험결과를 캡쳐한 화면이 빠져 있습니다-------
---------실제 보고서에는 실험결과가 함께 나타나 있습니다 -------

참고자료

· 없음