지표투과레이더와 적외선카메라를 이용한 아스팔트 포장 시공 관리 방법
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국도로학회
ㆍ수록지정보 : 한국도로학회논문집 / 17권 / 6호
ㆍ저자명 : 백종은, 박희문, 유평준, 임재규
ㆍ저자명 : 백종은, 박희문, 유평준, 임재규
목차
1. 서론2. 시공 중 품질관리를 위한 비파괴시험
3. 현장 시험
4. 현장 시험 결과
5. 결론
감사의 글
REFERENCES
영어 초록
PURPOSES : The objective of this study is to propose a quality control and quality assurance method for use during asphalt pavement construction using non-destructive methods, such as ground penetrating radar (GPR) and an infrared (IR) camera.METHODS: A 1.0 GHz air-coupled GPR system was used to measure the thickness and in situ density of asphalt concrete overlay during the placement and compaction of the asphalt layer in two test construction sections. The in situ density of the asphalt layer was estimated based on the dielectric constant of the asphalt concrete, which was measured as the ratio of the amplitude of the surface reflection of the asphalt mat to that of a metal plate. In addition, an IR camera was used to monitor the surface temperature of the asphalt mat to ensure its uniformity, for both conventional asphalt concrete and fiber-reinforced asphalt (FRA) concrete.
RESULTS: From the GPR test, the measured in situ air void of the asphalt concrete overlay gradually decreased from 12.6% at placement to 8.1% after five roller passes for conventional asphalt concrete, and from 10.7% to 5.9% for the FRA concrete. The thickness of the asphalt concrete overlay was reduced from 7.0 cm to 6.0 cm for the conventional material, and from 9.2 cm to 6.4 cm for the FRA concrete. From the IR camera measurements, the temperature differences in the asphalt mat ranged from 10℃ to 30 ℃ in the two test sections.
CONCLUSIONS: During asphalt concrete construction, GPR and IR tests can be applicable for monitoring the changes in in situ density, thickness, and temperature differences of the overlay, which are the most important factors for quality control. For easier and more reliable quality control of asphalt overlay construction, it is better to use the thickness measurement from the GPR.
참고 자료
없음"한국도로학회논문집"의 다른 논문
- 실 규모 터널 주행실험을 통한 터널 경계부 휘도 기준의 적정성 검증11페이지
- 도로전광표지를 이용한 국도우회정보 제공이 고속도로 운영에 미치는 효과 분석 -영동고속도로를 중심으로..8페이지
- 고속도로 오르막차로 교통사고 심각도 영향요인 분석11페이지
- 존별 특성을 반영한 교통사고밀도 모형 - 청주시 사례를 중심으로 -9페이지
- Random Parameter를 이용한 4지 신호교차로에서의 교통사고 예측모형 개발 : 부산광역시를..9페이지
- Laboratory Performance Evaluation of Recycled Asphalt B..9페이지
- 표면 에너지 원리를 이용한 칩실 포장의 초기 점착력 특성 연구8페이지
- 콘크리트 모듈러 도로 축하중 거동 분석을 통한 설계 타당성 검증9페이지
- 차량 이동궤적 기반 버스정차대 기하구조 연구4페이지
- 터널천단변위와 암석 또는 암반의 일축압축강도를 이용한 시공 중인 터널의 예비 안정성 평가6페이지