막여과 정수처리공정에서 망간에 의한 막오염 특성 및 화학세정효율 평가

서지정보

ㆍ발행기관 : 대한상하수도학회 ㆍ수록지정보 : 상하수도학회지 / 31권 / 6호
ㆍ저자명 : 강준석, 박서경, 송지영, 정아영, 이정준, 김한승

목차

1. 서 론
2. Methods
2.1. 시설현황
2.2 막여과시설 운영현황
2.3 유입수질 특성
2.4 세정 조건
3. Results and Discussion
3.1 계열별 막간차압 변화 추이
3.2 대상시설의 수질특성
3.3 약품세정 후 회복율 검토
3.4 약품세정 폐액 분석을 통한 막오염 물질 규명
4. Conclusions
사 사
References

영어 초록

In water treatment process using microfiltration membranes, manganese is a substance that causes inorganic membrane fouling. As a result of analysis on the operation data taken from I WTP(Water Treatment Plant), it was confirmed that the increase of TMP was very severe during the period of manganese inflow. The membrane fouling fastened the increase of TMP and shortened the service time of filtration or the cleaning cycle. The TMP of the membrane increased to the maximum of 2.13 kgf/cm2, but it was recovered to the initial level (0.17 kgf/cm2) by the 1st acid cleaning step. It was obvious that the main membrane fouling contaminants are due to inorganic substances. As a result of the analysis on the chemical waste, the concentrations of aluminum(146-164 mg/L) and manganese(110-126 mg/L) were very high. It is considered that aluminum was due to the residual unreacted during coagulation step as a pretreatment process. And manganese is thought to be due to the adsorption on the membrane surface as an adsorbate in feed water component during filtration step. For the efficient maintenance of the membrane filtration facilities, optimization of chemical concentration and CIP conditions is very important when finding the abnormal level of influent including foulants such as manganese.

참고 자료

없음