고성능 PRO 모듈 개발 및 운전조건이 모듈 성능에 미치는 영향
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 대한상하수도학회
ㆍ수록지정보 : 상하수도학회지 / 31권 / 4호
ㆍ저자명 : 한만재, 심연주, 이종화
ㆍ저자명 : 한만재, 심연주, 이종화
영어 초록
Pressure retarded osmosis(PRO) has attracted much attention as potential technology to reduce the overall energy consumption for reverse osmosis(RO) desalination. The RO/PRO hybrid process is considered as the most logical next step for future desalination. The PRO process aims to harness the osmotic energy difference of two aqueous solutions separated by a semipermeable membrane. By using the concentrated water(RO brine) discharged from existing RO plants, the PRO process can effectively exploit a greater salinity gradient to reduce the energy cost of processing concentrated water. However, in order to use RO brine as the draw solution, PRO membrane must have high water flux and enough mechanical strength to withstand the high operational pressure. This study investigates the development of a thin film composite PRO membrane and spiral wound module for high power density. Also, the influence of membrane backing layer on the overall power density was studied using the characteristic factors of PRO membranes. Finally, the performance test of an 8-inch spiral wound module was carried out under various operating conditions(i.e. hydraulic pressure, flow rate, temperature). As the flow rate and temperature increased under the same hydraulic pressure, the PRO performance increased due to the growth of water permeability coefficient and osmotic pressure. For a high performance PRO system, in order to optimize the operating conditions, it is highly recommended that the flow pressure be minimized while the flow rate is maintained at a high level.참고 자료
없음태그
"상하수도학회지"의 다른 논문
- 상수처리에서 염소 및 오존산화를 이용한 색도제거7페이지
- 수중 미량 잔류항생물질 Erythromycin, Sulfamethazine, Sulfathiazol..10페이지
- Mixotrophic microalgae에 의한 음폐수 소화액 고도처리에 있어 유기산이 microa..6페이지
- 인제거용 흡착제로서 밀스케일로부터 선별된 마그네타이트 적용 연구7페이지
- Ferrate(Ⅵ)를 이용한 발전소 탈황폐수 처리에 관한 연구5페이지
- 제지공정 폐수 전처리 수질예측을 위한 실험적 모델과 통계적 모델 개발8페이지
- 진공 막증류 공정의 스케일 막오염 형성에 관한 연구9페이지
- 전기응집-MBR 공정의 전류밀도와 접촉시간이 막 오염에 미치는 영향과 막 오염 저감 속도론적 고찰8페이지
- MD/RO 담수화 플랜트에서 발생한 농축수의 Ca 및 Mg 전처리를 위한 침전 처리 특성10페이지
- PVDF 중공사막을 이용한 진공 막 증류 모듈의 공급수 조건에 따른 열성능 특성에 관한 실험적 연구8페이지