6장 클램퍼 회로 예비레포트
- 최초 등록일
- 2017.06.20
- 최종 저작일
- 2017.03
- 9페이지/ MS 워드
- 가격 1,500원
목차
1. 실험에 관련된 이론
2. 실험회로 및 시뮬레이션 결과
3. 실험방법 및 유의사항
4. 참고문헌
본문내용
실험에 관련된 이론
<그 림>
A clamping circuit is used to place either the positive or negative peak of a signal at a desired level. The dc component is simply added or subtracted to/from the input signal. The clamper is also referred to as an IC restorer and ac signal level shifter.
In some cases, like a TV receiver, when the signal passes through the capacitive coupling network, it loses its dc component. This is when the clamper circuit is used so as to re-establish the the dc component into the signal input. Though the dc component that is lost in transmission is not the same as that introduced through a clamping circuit, the necessity to establish the extremity of the positive or negative signal excursion at some reference level is important.
A clamp circuit adds the positive or negative dc component to the input signal so as to push it either on the positive side, as illustrated in figure (a) or on the negative side, as illustrated in figure (b).
참고 자료
B. Razavi, “Fundamentals of Microelectronics,” John Wiley, 1st Edition, 2007, pp.380-410
https://www.youtube.com/watch?v=XYpY5NdjFxU
https://www.youtube.com/watch?v=LA7c7jenkd0