audio amplifier circuit design(예비)
- 최초 등록일
- 2011.07.09
- 최종 저작일
- 2009.03
- 12페이지/ 한컴오피스
- 가격 1,000원
* 본 문서는 한글 2005 이상 버전에서 작성된 문서입니다.
한글 2002 이하 프로그램에서는 열어볼 수 없으니, 한글 뷰어프로그램(한글 2005 이상)을 설치하신 후 확인해주시기 바랍니다.
소개글
audio amplifier circuit design(예비)
목차
1. Objective
2. Theory
3. Procedure
4. Simulation Result
(1) Power Supply for an Audio Amplifier
(2) Audio Amplifier
본문내용
3. Procedure
(1) Power Supply for an Audio Amplifier
A. PSPICE simulation
Conduct PSIPCE simulation for each step, and check the circuit system.
① Set the circuit as shown in fig 6-6, and get the half wave rectifying circuit signal.
② Set the circuit as shown in fig 6-7, and get the signal that has ripple.(To get ripple clearly, you can adjust capacitor)
③ Connect voltage regulator, then measure the wave. Is the ripple gone?
④ Set the circuit as shown in fig 6-11, measure the current flowing through transistor and the output signal of voltage regulator. Refer fig 6-4 for this PSPICE circuit diagram.
B. actual circuit design
① The Transformer
1) Apply commercial voltage(120Vrms 60Hz) to the primary side of transformer, inducing low voltage to the secondary side.
※ Caution : Never short secondary side.
2) questions
- Graph Vout using oscilloscope(Check Max, Min )
- Record Max/Min value of Vout.
참고 자료
없음