통신실험 결과 5,6 1. Indirect Method of Generating FM Signals 2. The Tunable Receiver
- 최초 등록일
- 2014.12.05
- 최종 저작일
- 2014.09
- 9페이지/ 한컴오피스
- 가격 1,000원
목차
1. Indirect Method of Generating FM Signals
2. The Tunable Receiver
본문내용
Indirect Method of Generating FM Signals
1. Set up modules as shown in Figure 5-11. Make sure that all OUTPUT LEVEL and GAIN controls are turned fully counterclockwise to the MIN position, and power up the equipment.
2. Set the RF GAIN of A _{2} on the Indirect FM / PM Generator to 50% clockwise. With no signal applied at the AUDIO INPUT of the Indirect FM / PM Generator, measure the frequency of the signal at TP6, and at the PM / NBFM RF OUTPUT and record your measurements. Figure 5-10 shows where these two measurement points are located in the circuit. Use a × 1 probe at the Frequency Counter input when measuring frequency at a test point.
<중 략>
장치로써 일정범위를 갖는 RF Filter의 frequency band(88~108MHz)를 이용하여 RF signal을 선택하여 수신할 수 있는 receiver라는 것을 배우게 되었다. 특히Quadrature Detector 전에 AGC를 포함한 Feed Back 회로를 통하는 신호는 크기가 제한되어 일정한 값의 출력신호 만이 측정되는 모습이 인상 깊었다. 마지막으로 결과 값을 그래프 화 했을 때 그 값이 Linear하다는 것을 관찰 할 수 있었다. 즉 리미터는 출력을 제한하는 역할을 한다는 것과 IF filter의 역할 등등 을 실제로 실험 결과 같을 통해 확인하고 그동안 이론으로만 접해왔던 지식을 스스로 다시 검증해 볼 수 있었다.
참고 자료
없음