3차원측정기를 이용한 측정 시 측정시편 셋팅방법에 따른 오차발생에 관한 연구
(주)코리아스칼라
- 최초 등록일
- 2023.04.10
- 최종 저작일
- 2023.02
- 5페이지/ 어도비 PDF
- 가격 4,000원
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국기계기술학회
ㆍ수록지정보 : 한국기계기술학회지 / 25권 / 1호
ㆍ저자명 : 정현석, 왕현철
영어 초록
In this study, measurement errors of the X and Y axes were verified by using an 80-100 mm gauge block, an NPL type angle measuring device, and a spelling on a contact-type 3D measuring device surface plate. In addition, the measurement specimen was repeatedly measured 10 times at 10° intervals from 0° to 40° to confirm the average value and standard deviation. After confirming the statistical test value (P) through ANOVA analysis of the statistical program, the correlation between angle change and error was confirmed.
참고 자료
없음
"한국기계기술학회지"의 다른 논문
더보기 (5/10)