플라스틱 렌즈 사출에서의 변위 해석에 관한 연구
(주)코리아스칼라
- 최초 등록일
- 2023.04.05
- 최종 저작일
- 2017.08
- 6페이지/ 어도비 PDF
- 가격 4,000원
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국기계기술학회
ㆍ수록지정보 : 한국기계기술학회지 / 19권 / 4호
ㆍ저자명 : 이주상, 윤상진, 김치균
영어 초록
Smart phones are currently the most popular electronic devices with high volume production activities driven by high demand and requirements for rapid turnaround time. The changes of displacement were analyzed according to a variable of the gate size and runner system. The radial type and gate with large size were shown that better results in displacement. While the design and production of lenses, the key component of a camera, still need to be improved, the current technology has run into its limit with regard to trends in size and weight reduction. In this study, an injection molding analysis was performed on plastic lenses that are widely employed for smart phone cameras. Specifically, the displacement of lenses at the time of injection molding was studied by varying the gate size and runner system.
참고 자료
없음
"한국기계기술학회지"의 다른 논문
더보기 (5/10)