굴림석 자동화 시스템 개발
(주)코리아스칼라
- 최초 등록일
- 2023.04.05
- 최종 저작일
- 2016.12
- 6페이지/ 어도비 PDF
- 가격 4,000원
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국기계기술학회
ㆍ수록지정보 : 한국기계기술학회지 / 18권 / 6호
ㆍ저자명 : 원대희
영어 초록
In this study, design and manufacturing automation systems for the rolling stone rolling stone production were as follows. Manufacturing of rolling stone was designed to obtain a desired rolling round for about 5-15° by the tilted the tilted the slope of the road rolling barrel. This stone can be manufactured by the conflicting with each other inside the barrel. Additionally, the stone cutting device was made to cut the stone having the standard sizes of this rolling stone about 100x100x100 mm for height, width, depth, respectively. Rolling stone was transferred to a cutting device using a conveyor belt, while a rubber on the conveyor belt was used to prevent the slip between the stone and this conveyor belt. The production of this rolling stone device was measured by a counter system, which was installed at the end of the conveyor belt bottom of the outlet.
참고 자료
없음
"한국기계기술학회지"의 다른 논문
더보기 (5/10)