사출금형 측면리브의 슬로터 가공에 관한 연구
(주)코리아스칼라
- 최초 등록일
- 2023.04.05
- 최종 저작일
- 2017.06
- 6페이지/ 어도비 PDF
- 가격 4,000원
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국기계기술학회
ㆍ수록지정보 : 한국기계기술학회지 / 19권 / 3호
ㆍ저자명 : 김 선삼, 김 옥래, 조 대희, 우 창기
영어 초록
The ribs of the injection molded article are a necessary shape in order to maintain the rigidity without increasing the material cost. The ribs on the outside of the molded article in the form of a housing are located on the side of the cavity inside in the mold. This paper proposes slotting by machining side-ribs. The slotting was performed through CNC control along the edge profile of the rib width. The machining time and the roughness of the machined surface were compared to verify the machining efficiency and the practicality of the machining method as a side-rib machining method.
참고 자료
없음
"한국기계기술학회지"의 다른 논문
더보기 (5/10)