미세심공드릴 가공에 있어서 Be-Cu 재료의 절삭조건에 관한 연구
(주)코리아스칼라
- 최초 등록일
- 2016.04.02
- 최종 저작일
- 2000.06
- 10페이지/ 어도비 PDF
- 가격 4,000원
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 대한안전경영과학회
ㆍ수록지정보 : 대한안전경영과학회지 / 2권 / 2호
ㆍ저자명 : 김희남, 유숙철, 이형원, 이원영, 이종화, 이인수
영어 초록
Recently micro deep hole drilling is required in the whole industry. However, micro deep hole drilling has still much difficulty because of the lack of drill rigidity and the interruption of chip. We treated a micro deep hole(diameter 0.35mm, depth 3mm) used in a connector jack pin. Therefore, a surface roughness is very important. In this paper, we studied on the variation of the surface roughness for cutting conditions during micro deep hole drilling of Be-Cu material. Most of all, we tried to drill on CNC for the realization of automatization.
참고 자료
없음
"대한안전경영과학회지"의 다른 논문
더보기 (5/10)