메카트로닉스 opamp 과제
- 최초 등록일
- 2014.11.11
- 최종 저작일
- 2014.09
- 8페이지/ 한컴오피스
- 가격 1,000원
소개글
메카트로닉스 opamp 과제 #2 for kut
목차
1. Mechatronics Experiment
2. Equipment
3. LM741(8pin)
4. Exp#1-1 Voltage follower 1
5. Exp#1-2 Voltage follower 2
6. Exp#2 Inverting Amplifier
7. Exp#3 Non-inverting Amplifier
8. Exp#4 Integrating Amplifier
9. Exp#5 Differentiating Amplifier
본문내용
Mechatronics Experiment
Task 1: Voltage follower circuit construction
Task 2: Inverting Amplifier circuit construction
Task 3: Non-Inverting Amplifier circuit construction
Task 4: Integrator circuit construction
Task 5: Differentiating circuit construction
Equipment
1. Op-amp LM741
2. Resistor 1K(2),9K(1) ,10K(2)
3. Capacitor 1uF
4. Power supply
5. Oscilloscope
LM741(8pin)
Exp#1-1 Voltage follower 1
- Vin : 2V pk-pk 1kHz sine wave
- Make a plot of two resulting waveforms
LM741의 특성은 V2과 V3이 같아야 한다. 그리고 증폭기의 임피던스가 무한대와 같다면 Exp#1-1의 결과는 입력과 출력이 같아야 한다.
두 파형의 스케일을 같게 했을 때 같은 파형으로 확인 되는 것을 보아 입력과 출력이 같다는 것을 알 수 있다.
참고 자료
없음