CCNA요약

목차

1. Update time & Hold time
2. Roting Protocol
3. Access List Number
4. Access List
5. Spanning-Tree Protocol(STP, IEEE802.1d)
6. Difference of Bridge & Switching
7. Switching Method
8. Full duplex
9. Duplex Mismatches
10. Editing key
11. show cdp neighbors
12. show cdp entry * (= show cdp neighbors detail)
13. Prevent Loops method
14. PPP
15. ISDN Standards
16. LMI types
17. Hierarchical Model
18. Default Distance(Administrative distance)
19. IP address
20. Port #
21. Holddown
22. ICMP
23. CIR( from Frame relay)
24. Stub Network
25. Cisco Encapsulation Types
26. Get Nearest Sever Protocol(GNS)
27. ISDN
28. OSI 7 layer
29. OSI 7 layer를 정한 이유
30. interface is up , line protocol is down
31. Findind the IOS( Order of search)
32. RAM - Routing table
33. Switching Functions
34. Config the Switch
35. address-violation
36. VLAN Membership Modes
37. Benefits to segmenting with router
38. Benefits to segment with Bridge
39. Router Command
40. Switch(1900) Command
41. Advantage of reference models
42. for port states of an STP switch
43. Spanning-Tree Port States
44. BPDU & VTP
45. Catalyst 1900 Default Config
46. Config Register Values
47. ROM functions
48. Encapsulation Data

본문내용

CCNA 정리자료1. Update time & Hold time

RIP - 30', 180'
CDP - 60', 180
IGRP- 90',
IPX RIP - 60' , SAP - 60'
IARP-60' , LMI-10'

2. Roting Protocol
1)RIP - hop count(Max=15), classful routing protocol(not send the subnetmask along with the routing updated)
2)IGRP - Bandwidth, Delay, Loading, MTU, Reliability(Max=255)
3)IPX RIP - ticks(about 1/18 sec.), hop count(Max=15)

참고 자료

없음